Brennenstuhl 1172660 Service Manual download pdf (Page 19)

Power Jet-Light 4 x 36 W IP 54

Operating Manual 19 Status: 7201S-07-2007_K

Step Activity

Disconnect the wire. For this purpose, detach the pull relief and press the wire button to the

wire block.

Pos. Name

8 Wiring

19 Pull relief

20 Wire button

21 Wire block

Detach the bush by rotating in the anti-clockwise pattern.

Pos. Name

13 Casing

14 Bush including bending protection

6 Unscrew the old wiring.

WARNING: Use only original accessory of the same type during replacing the wiring

and the same wiring length.

IMPORTANT: The green / yellow earthing wire must always be 3 cm longer than both

the other wiring.

Retract the wiring.

8 Clamp the wiring in the wire block. For this purpose, press the wire button and push the

wiring in the wire block.

9 Bolt the bush.

10 Position the metal plate. Fasten the metal plate with the previously removed bolts.

11 Fit the reflector in the casing. Fasten it with the reflector bolts.

12 Mount the illuminant (See chapter replace illuminant step 4+5)

IMPORTANT: Check all the bolted connections before the initial operation.

7 Cleaning

Pull the main plug before cleaning. Due to reasons of the electrical security, the device is to be cleaned

with a dry or damp cloth. Please do not use any sharp cleaning material or chemicals (solvents, petrol

etc) and no rough sponges. Never dip the working lamp in water.

8 Waste Disposal

The product should not be disposed in normal domestic waste at the end of its lifetime. Please enquire

with your city or municipal administration on possibilities of environmentally compatible and appropriate

disposal of the device.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 67 68

No comments

Brennenstuhl 1172660 Service Manual Page 19